[Home]History of TubeCutter

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Revision 12 . . (edit) August 27, 2006 3:47 pm by Robinsz
Revision 10 . . (edit) August 27, 2006 4:25 am by Robinsz
  

Difference (from prior major revision) (minor diff)

Added: 108a109,114
It is most important to note that upon selection of a new face, with M3 on, the Y value will change from (for example #2002 (for A2) to #2011 (for B1)) the adjacent pairs of edge lines are:

A1 and D2, A2 and B1, B2 and C1, C2 and D1, D2 and A1

face selection (with M3 active) always starts with the Y position at one edge of a pair, and ends with Y at the other edge of the pair. Not sure what happens with M3 off, maybe Y will remain umoved.


LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Search:
Published under a Creative Commons License