History of SteppersAndBallscrews

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Difference (from prior major revision) (author diff)

Changed: 10c10

For Steppers it's best to go for full torque and best speed -> that means 400Steps/Revolution? or half stepping.

For Steppers it's best to go for full torque and best speed -> that means 400Steps / Revolution or half stepping.

Changed: 12c12

This will end up in a 4 on 5 System that means 1,25 DIV/Mult?.

This will end up in a 4 on 5 System that means 1,25 DIV / Mult.

Changed: 15,17c15,17

Those are good combinations:
1) Tiny steppers with 1/8 (6,25mm) 20/25 20 on stepper 25 on axis spindle.
2) The 1,25mm to the system 32/40 teeth that will fit bigger shafts.

Those are good combinations:

1) Tiny steppers with 1/8 (6,25mm) 20/25 20 on stepper 25 on axis spindle.

2) The 1,25mm to the system 32/40 teeth that will fit bigger shafts.

Published under a Creative Commons License

	Revision 3 . . June 21, 2014 5:02 pm by XXCoder [oops fix]
	Revision 2 . . June 21, 2014 5:00 pm by XXCoder [grammar fix]
	Revision 1 . . June 19, 2014 6:01 pm by Sammellothar [new page]