History of RtosConsolidated

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Difference (from prior major revision) (no other diffs)

Added: 54a55

<KARnote: On a freshly installed Ubuntu 12.04LTS virtual machine on an x86 host, I pulled from master at about 1500EDT on 20130607, checked out rtos-master-v0, configured for a simulator, and built both the LinuxCNC simulator and all the docs---PDF and HTML---without incident. Well, there was a complaint at the end that checklink was not found but this is a problem introduced upstream. />

Published under a Creative Commons License

	Revision 8 . . June 8, 2013 12:42 am by CNCDreamer *[added KARnote about successful build of sim and docs]**
	Revision 7 . . June 7, 2013 10:42 am by MichaelHaberler
	Revision 6 . . June 7, 2013 7:29 am by MichaelHaberler
	Revision 5 . . June 7, 2013 6:14 am by MichaelHaberler
	Revision 4 . . June 7, 2013 5:55 am by MichaelHaberler
	Revision 3 . . June 7, 2013 5:36 am by MichaelHaberler
	Revision 2 . . June 7, 2013 5:35 am by MichaelHaberler
	Revision 1 . . June 7, 2013 5:34 am by MichaelHaberler