[Home]History of HobbyCNC

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Revision 5 . . (edit) August 3, 2018 1:11 pm by Bvolken
Revision 4 . . August 3, 2018 1:10 pm by Bvolken [Updated info on new (Rev2) board version.]
Revision 3 . . (edit) March 17, 2009 10:01 am by BrianG
  

Difference (from prior major revision) (minor diff)

Added: 0a1,7
The HobbyCNC PRO Rev 2 Board addresses the issue described below. The 10 second 'Idle Current Reduction' feature has been removed.
In its place is a more traditional 'Enable' signal (Pin 1 of the 25 Pin D connector). As designed, the enable signal will cut the motors to half current. This can be adjusted by changing a resistor value. The remainder of the board remains the same.

BrianV?, HobbyCNC





LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Search:
Published under a Creative Commons License