[Home]History of ContributedComponents

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Revision 101 . . October 26, 2017 2:30 pm by KimK [Add nowiki tags to LinuxCNC mentions.]
Revision 100 . . March 18, 2017 8:49 am by Andyough
Revision 99 . . August 31, 2015 8:17 pm by Tome [Updated toolerator.ino]
  

Difference (from prior major revision) (no other diffs)

Changed: 6c6
This page is a place for users to contribute HAL components and other LinuxCNC/HAL-related information in the hope that they will be useful to others.
This page is a place for users to contribute HAL components and other LinuxCNC/HAL-related information in the hope that they will be useful to others.

Changed: 19c19
**LinuxCNC versions 2.6.n and earlier:
**LinuxCNC versions 2.6.n and earlier:

Changed: 21c21
**LinuxCNC versions 2.7.0 onwards
**LinuxCNC versions 2.7.0 onwards

Changed: 24c24
**LinuxCNC versions 2.6.n and earlier:
**LinuxCNC versions 2.6.n and earlier:

Changed: 26c26
**LinuxCNC versions 2.7.0 onwards:
**LinuxCNC versions 2.7.0 onwards:

Changed: 29c29
Clearly label each submission with its license. Submissions hosted on linuxcnc.org must be as free or freer than emc2. This means approximately that they have a license accepted under the [Debian Free Software Guidelines]. GPL and LGPL are two examples of permitted licenses. "Free For Noncommercial Use" is an example of a non-permitted license.
Clearly label each submission with its license. Submissions hosted on linuxcnc.org must be as free or freer than </nowiki>LinuxCNC</nowiki>. This means approximately that they have a license accepted under the [Debian Free Software Guidelines]. GPL and LGPL are two examples of permitted licenses. "Free For Noncommercial Use" is an example of a non-permitted license.

Changed: 32,33c32,33
*For ".comp" components compatible with EMC2.1 and later, also specify MODULE_LICENSE("...");.
*For ".comp" components compatible with EMC2.2 and later, also specify license "...";
*For ".comp" components compatible with LinuxCNC (EMC2.1 and later), also specify MODULE_LICENSE("...");.
*For ".comp" components compatible with LinuxCNC (EMC2.2 and later), also specify license "...";

Changed: 429c429
[upload:testpanel.tar.gz]
[upload:testpanel.tar.gz]

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Search:
Published under a Creative Commons License