The board is compatible with EtherCAT protocol. With a maximum output frequency up to 1MHz, it is ideal for applications with step motors, and applications with burst piloted brushless motors. The board manages up to 5 axes in frequency, 4 inputs, 2 outputs, 1 DAC of 12 bit and 2 ADC of 12 bit. The board is supplied with all connectors and can be installed on DIN guide. Since it is a compatible slave EtherCAT board, it is possible to use it with any EtherCAT Master board of AxesBrain? or LinuxCNC type or other.
•5-CH 5Volt for frequency signals pulse •5-CH 5Volt for direction signals The frequency and direction signals can be in: 1 differential mode (1MHz) 2 single ended positive mode (250KHz) 3 single ended negative mode (250KHz) •5-CH 5Volt for enable/boost signals •5-CH DI 24Volt for motor drives OK •1-CH DI 24Volt for inverter drive OK •5-CH DI 24Volt for home microswitch •4-CH DI 24Volt for general purpose •5-CH DI fast input for motor index (Z) •5-CH DO 24Volt-200mA NPN to enable motor servodrive •1-CH DO 24Volt-200mA NPN to enable inverter servodrive •2-CH DO 24Volt-200mA NPN for general output •1-CH 12 bit analog-output +- 10Volt •2-CH 12 bit analog-input 0+10Volt, input impedance 1Mohm, high precision for measuring device •1 source output 5V for precision Switch •1 receive low current, high speed signal from precision Switch