[Home]History of Hardware Requirements

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Revision 30 . . March 15, 2016 10:37 pm by Tylercolbert
Revision 29 . . July 7, 2012 1:08 pm by Archivist [fix bad links emcinfo.pl->wiki.pl]
  

Difference (from prior major revision) (no other diffs)

Changed: 25c25
Diskspace requirements are low: 4GB is plenty---over 1.2GB is still free after installing dapper, emc2, and the software needed to rebuild emc2. The (currently unsupported) "puppy emc2" will install in a small (128MB or less?) hard drive; it will even run totally in ram, but you still need somewhere to put your configuration files.
Diskspace requirements are low: 4GB is plenty---over 1.2GB is still free after installing dapper, emc2, and the software needed to rebuild emc2. The (currently unsupported) "puppy emc2" will install in a small (128MB or less?) hard drive; it will even run totally in ram, but you still need somewhere to put your configuration files. (TylerColbert?: My attempts to install from the livecd on to a 4GB compact flash ran out of space, 800MB used for swap, so it was about 3.2GB available)

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Search:
Published under a Creative Commons License