[Home]History of EMC With Custom Kernel

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Revision 69 . . (edit) February 22, 2014 12:45 pm by Belerafon
Revision 68 . . (edit) September 8, 2009 8:47 pm by Acemi
Revision 66 . . May 7, 2009 7:47 pm by EricJ
  
Difference (from prior major revision) (minor diff, author diff)

Changed: 15c15
Partition 1: Partition for building the original kernal to be applied to EMC.

Partition 1: Partition for building the original kernel to be applied to EMC.


Changed: 22c22
Use partition #1 to build the custom kernel. Once the kernel is built, save the ".config" file created from building the kernel, it will be required later. To prevent package conflicts, using a fresh install of Ubuntu 8.04 is highly recommended. Once Ubuntu is installed, ignore any prompts to install updates at least until after successfully completing the steps described here.
Use partition #1 to build the custom kernel. Once the kernel is built, save the ".config" file created from building the kernel, it will be required later. To prevent package conflicts, using a fresh install of Ubuntu 8.04 on the second partition is highly recommended. Once Ubuntu is installed, ignore any prompts to install updates at least until after successfully completing the steps described here.

Added: 32a33,34
Also you can find kernel source here: http://www.linuxcnc.org/dists/lucid/base/source/


Removed: 190d191

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
Search:
Published under a Creative Commons License