[Home]Released 2.6.X

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Showing revision 13

2015 October 2: LinuxCNC 2.6.10

Changes since 2.6.9:

2015 August 11: LinuxCNC 2.6.9

Changes since 2.6.8:

2015 May 11: LinuxCNC 2.6.8

Changes since 2.6.7:

2015 February 21: LinuxCNC 2.6.7

Changes since 2.6.6:

2015 February 19: LinuxCNC 2.6.6

Changes since 2.6.5:

2014 December 9: LinuxCNC 2.6.5

Changes since 2.6.4:

2014 November 1: LinuxCNC 2.6.4

Changes since 2.6.3:

2014 September 5: LinuxCNC 2.6.3

Changes since 2.6.2:

2014 August 10: LinuxCNC 2.6.2

Changes since 2.6.1:

2014 August 5: LinuxCNC 2.6.1

Changes since 2.6.0 include:

2014 July 28: LinuxCNC 2.6.0

Notes on updating from 2.5 to 2.6 are here: http://wiki.linuxcnc.org/cgi-bin/wiki.pl?UpdatingTo2.6

Changes since 2.5 include:

    * VFS11 VFD
    * Delta VFD-B
    * WJ200 VFD
    * General Mechatronics
    * XHC-HB04 jog pendant
    * Mesa 5i24 AnyIO? board
    * Mesa 7i90 AnyIO? board
    * Mesa 7i65 (SPI 8xservo controller)
    * Absolute encoder support including SSI, BISS and Fanuc encoders
    * Encoder module enhancements including settable sample rate, count error reporting and muxed encoder cable deskew


LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
This page is read-only. Follow the BasicSteps to edit pages. | View other revisions | View current revision
Edited October 2, 2015 10:12 pm by Seb Kuzminsky (diff)
Search:
Published under a Creative Commons License