[Home]UpdatingTo2.2

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Difference (from prior author revision) (major diff)

Changed: 8c8
gpg -a --export 96935D7D | apt-key add -
gpg -a --export 96935D7D | sudo apt-key add -

Because (minor) changes to configuration files are needed, your existing install will not automatically be updated to 2.2. If you want to run 2.2, you will have to change to the EMC 2.2 repository by following these instructions:

Open the terminal window. Enter the following commands:

    gpg --keyserver pgpkeys.mit.edu --recv-key 96935D7D
    gpg -a --export 96935D7D | sudo apt-key add -      
Enter the password where prompted in order to run the administrative commands. If you don't perform this step, you will get a warning about "unauthenticated software" when installing bugfix releases.

run System/Administration/Synaptic Package Manager

go to Settings/Repositories

In the list of Channels are two lines for linuxcnc.org. (If there are no entries for linuxcnc.org see [Repository Updating]?)

For each of them:

Close the "Software Preferences" window

Click "Reload" as instructed

Click "Mark All Upgrades"

Click "Apply"

Once you have done the upgrade, you will need to update any custom configurations by following these instructions: UPDATING


LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
This page is read-only. Follow the BasicSteps to edit pages. | View other revisions
Last edited November 12, 2007 6:48 am by CPE-76-84-175-49.neb.res.rr.com (diff)
Search:
Published under a Creative Commons License