[Home]DebianInstall

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Difference (from prior major revision) (no other diffs)

Changed: 20c20
You may wish to compile the latest version of emc2 from CVS.
You may wish to compile the latest version of emc2 from Git.

Changed: 28,35c28
cvs -z5 -d:ext:anon@cvs.linuxcnc.org:/cvs co emc2
cd emc2/src
./configure --enable-run-in-place
make
sudo make setuid
sudo chmod a+rx ../bin/emc_module_helper
../scripts/emc

then follow the instructions on Installing EMC2

Step 1, get debian Etch by the usual net or cd based installers

Step 2 add the following to your /etc/apt/sources.list file:

 deb http://www.linuxcnc.org/emc2/ dapper emc2
 deb-src http://www.linuxcnc.org/emc2/ dapper emc2

then do:

 sudo apt-get update
 sudo apt-get install emc2-axis

Step 3: relax.

Step 4: reboot. make sure uname -r says " 2.6.15-magma" and edit /boot/grub/menu.lst to boot the realtime kernel by default.

Step 5: type 'emc' at the prompt.


You may wish to compile the latest version of emc2 from Git.

 sudo apt-get build-dep emc2-axis

edit /usr/realtime*/bin/rtai-config to say: RTAI_CC="gcc-4.0" instead of RTAI_CC="gcc"

then follow the instructions on Installing EMC2


LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
This page is read-only. Follow the BasicSteps to edit pages. | View other revisions
Last edited June 20, 2009 8:15 am by JeffEpler (diff)
Search:
Published under a Creative Commons License