[Home]Alpha1125

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Who is Alpha1125?

Well, I'm just a irc rat learning to use emc.

You can contact me the following ways:
IRC: A-L-P-H-A on irc://irc.freenode.net/emc

Website: [Lloyd Leung]

- My system uses three gecko g201 stepper drivers, to drive my 3 axis mill.

Trials and tribulations towards getting BDI 4.20 to work: - The X and Y axis are 12,800 pulses per inch. (0.25 ipr on 48:30 gearing) - The Z axis is 32,000 pulses per inch. (0.1 ipr on 48:30 gearing)

Trying to get _any_ speed was pully teeth.

So I just stuck with the standard period of 0.000024 in the ini file. And set my speeds to a dismal 19.2 ipm (X&Y), and 4.8 ipm (Z).


LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org
This page is read-only. Follow the BasicSteps to edit pages. | View other revisions
Last edited June 16, 2005 3:48 pm by Alpha1125 (diff)
Search:
Published under a Creative Commons License