History of Pncconf

LinuxCNCKnowledgeBase | RecentChanges | PageIndex | Preferences | LinuxCNC.org

Difference (from prior major revision) (minor diff)

Changed: 2,4c2,4

Pncconf is a work in progress. (could be broken at any time) It is available in trunk.

Right now it supports the Mesa 5i20,5i22,5i23,7i43 cards with a few different firmware each.

if successful and I would hope to add other hardware cards/systems (eg ppmc)

Pncconf is a work in progress. Alpha srage

Right now it supports the Mesa 5i20,5i22,5i23,7i43 3x20 cards with a few different firmware each.

I would hope to add other hardware cards/systems in the future (eg ppmc)

Changed: 7c7

if you have a current master and wish to try it open a terminal, type '. scripts/emc-environment', then 'pncconf'

if you wish to try it open a terminal, then type 'pncconf'

Removed: 18d17

The Mesa test panel needs more work to cover some of the firmwares but will work to check GPIO.

Changed: 103,104c102,108

|| This is the basic info for a machine
-similar to stepconf.
You can have two Mesa card now.

The limit and home options change the signal names avalable in the parport and mesa pages||

||This is the basic info for a machine
-similar to stepconf.
You can have two Mesa card now.

The limit and home options change the signal names avalable in the parport and mesa pages ||

1.1. External Controls page

||This is for external jogging / rapid controls and limit / homing switched. ||

1.2. GUI page

||This is for loading different GUI frontends and setting defaults. Pyvcp panels are also selected here. ||

Published under a Creative Commons License

	Revision 22 . . (edit) October 12, 2010 6:42 am by Chester
	Revision 20 . . (edit) January 24, 2010 11:36 pm by Chester