History of LinuxCNC Fest 2014

	Revision 17 . . October 16, 2014 4:14 pm by outpost.timeguy.com [Please bring me a power supply!]
	Revision 16 . . October 13, 2014 7:06 pm by JeffEpler
	Revision 15 . . October 13, 2014 7:04 pm by JeffEpler
	Revision 14 . . October 3, 2014 6:31 am by Jmkasunich
	Revision 13 . . (edit) October 2, 2014 4:11 am by Jmelson
	Revision 12 . . (edit) October 2, 2014 4:10 am by Jmelson
	Revision 11 . . (edit) October 2, 2014 4:10 am by Jmelson
	Revision 10 . . October 2, 2014 4:09 am by Jmelson [Jon Elson stuff]
	Revision 9 . . September 25, 2014 9:23 pm by Rtavk3
	Revision 8 . . (edit) September 19, 2014 2:55 pm by outpost.timeguy.com [Me too]
	Revision 7 . . September 19, 2014 1:10 pm by Mozmck
	Revision 6 . . September 19, 2014 3:59 am by Floppy
	Revision 5 . . September 18, 2014 9:43 pm by Tensaiteki
	Revision 4 . . September 18, 2014 9:36 pm by Tensaiteki
	Revision 3 . . September 18, 2014 9:36 pm by Tensaiteki
	Revision 2 . . September 18, 2014 9:36 pm by Tensaiteki
	Revision 1 . . September 18, 2014 9:30 pm by Tensaiteki

Difference (from prior major revision) (no other diffs)

Added: 51a52

* Gantry homing test jig with servos/encoders with index/home switches - Chris Radek

Added: 55a57

* Power supply, 24ish volts at a few amps - Chris Radek

Published under a Creative Commons License